Operation

Check that the control knob is in the raised position, pull it back, and then open the hinged lid.

Fill the main reservoir to the MAXIMUM level and close the lid using a firm downward pressure.

Ensure that the control knob clicks back into the closed position and the lid is securely closed.

Place the ECO Kettle on its power base and plug in the power cord to a standard domestic power socket and switch on.

You are now ready to decide how much water you wish to boil – from one cup to the full kettle!

To deliver water to the boiling chamber, press down firmly on the control knob until water flows into the boiling chamber.

Watch the water level rise in the front window until it reaches the required mark.

For your guidance:

• One small cup = 150 to 200ml
• One large cup/mug = 200 to 300ml

When the control knob is released the valve closes and the water in the boiling chamber is ready to boil.

Always ensure there is enough water to reach the “Min Fill” mark (approximately one cup = 200ml).

Never fill above the “Max Boil” mark on the boiling chamber window as water may be ejected during boiling.

Switch the ECO Kettle ON by selecting one of the buttons on the power base. 80 deg,(speciality teas etc), 90 deg ( Coffee) or Boiling The selected button will flash to indicate the ECO Kettle is ON.

When the selected temperature is reached , an audible alarm will sound and your ECO Kettle will switch OFF automatically.

You can simply stop the heating process at any time by pressing the selected button again. Please note that when you select 80deg or 90deg the electronic control cycles the heating element on and off to ensure that the selected temperature is not exceeded.

Always wait until the button stops flashing and the alarm sounds to achieve the correct temperature.

If you do not use the water immediately, it can be brought back to the selected temperature by pressing the button again. It may be necessary to wait a few seconds before the switch can be reset.

If at any time you wish to heat all of the water in the kettle – including the water contained in the reservoir simply lock the valve open by pressing the control knob down firmly and rotating it clockwise.

Do not leave the valve in the locked position as this will prevent your ECO Kettle from saving energy and may make the lid seal less effective.

If the ECO kettle is inadvertently operated without water in the boiling chamber an automatic cut out will operate to protect your ECO kettle. This can simply be re-set as follows:

Cool the heating element – this can be quickly be achieved by releasing cool water from the reservoir into the boiling chamber.

Wait for a short time for the control to cool sufficiently and the ECO Kettle will then be ready for use again.

Top up the reservoir to the maximum level from time to time as necessary, so that your ECO Kettle is always ready to heat the exact amount of water you require.

To ensure the water in your ECO Kettle does not get stale, start each day by discarding any remaining water and refilling with fresh.

Looking after your ECO Kettle

The ECO Kettle is provided with a removable filter in the spout to remove limescale etc. If it becomes clogged, remove and clean under running water.

To maintain optimum performance, it will be necessary from time to time to clean the ECO Kettle to remove limescale deposits. This can be achieved simply by using a proprietary cleaner made specially for plastic bodied kettles, and following the makers instructions.

The outside of your ECO kettle should be kept clean using a damp, soft cloth. Do not use abrasive cleaners as these will scratch the surfaces.

Never immerse the ECO kettle or its power base in water.